2. analog
  3. 1228934026

Subsonic Rumble Solutions

I know many of you have tried to address this issue. Short of buying or building a subsonic filter (that will/may negatively affect your transparency) - what methods reduce subsonics (meaning the pumping of woofers and subs when a record is playing)?

My system:
I have a DIY VPI Aries clone with a 1" thick Corian plinth, a Moerch DP6 tonearm and Dynavector 20X-H cartridge. This sits on a maple shelf. The shelf sits on squash balls. The balls sit on another maple board floating in a 3" deep sand box. All this on a rack spiked to a cement floor. The phono stage is a Hagerman Trumpet (no built in subsonic filter and very wide bandwidth). I use the 1 piece Delrin clamp on the TT. Yes, I clean records thoroughly and there are no obvious warps, especially after being clamped.

So my isolation is very good - no thumps or thwacks on the rack coming through the speakers. But if I turn the sub on I get that extra low end pumping on some records that hurts my ears. Mostly I leave the sub off when playing vinyl, but I would like to use it if possible.

There was some brief discussion of this on Albert Porter's system thread. I'm hoping to get more answers here.

So ... what methods have you tried to reduce subsonics that you have found effective?

Thanks,
Bob
ptmconsulting
acoustat6
357 posts
 
Hi Markpao, you said "Yes, I did receive the 20hz subsonic filters and installed them at my pre amp out. There was no question that the woofer pumping was reduced, but not gone."

Dont forget that the 20hz filter will only reduce the freq below 20 hz at a rate as specified by the manufacturer (usually 18-24db per octave). It is not a sharp cutoff that will totally eliminate 20hz and below.

Also don't forget that you have not addressed the other side of this coin, rumble. Not turntable rumble, but record rumble.

Bob
eldartford
4,262 posts
 
I don't know if anyone has suggested this yet, but try switching your system to Mono. If the preamp doesn't have a Mono switch, invest a couple of bucks in a Y-adapter interconnect at radio shack. If this cures your problem, as I suspect it will, you need a rumble filter that mixes channels below some frequency higher than 20 Hz. (The Y-adapter mixes at all frequencies).
koegz
317 posts
 
let's see, subsonic filter, rumble filter how about an air filter? to bright ad a tweeter filter. mids not right add a mid booster filter. how about, system sounds bad, get a better system.
srwooten's avatar
srwooten
694 posts
 
I was having the same woofer pumping problems with my Scoutmaster/Dyna 20X-H and tried a Speed mat. It did not help, nor did it (the mat) work with the ring clamp. What did help was a cartridge upgrade and proper cartridge alignment. It may have just been the alignment though- I did them both at the about same time. Some records still have the problem, though greatly diminished.
acoustat6
357 posts
 
Koegz said, "let's see, subsonic filter, rumble filter how about an air filter? to bright ad a tweeter filter. mids not right add a mid booster filter. how about, system sounds bad, get a better system."

Hey koegz, no need to worry about a subsonic filter when your speakers (B&W 800D) are allready down -3db at 35hz and are -6db at 25 hz!! You allready have a built in subsonic filter.And rumble, just think how much less rumble (and music) you are missing when your speaker is incapable of much below 50hz.

Ponder that for a moment and when you get full range capable speakers let us know.

Bob
More to discover