Record Clamps?

Fight, Yes there are many clamps that drop on. I use those on my tables. I clean with a VPI Typhoon and the two piece screw down design is a must. No label damage, no way. If I had a threaded spindle on a TT, same answer.

Jay, I'm not intimately familiar with your Turntable, and its Spindle, is it 1/4"-20 Threaded as the VPI is?

In actuality, the VPI Threaded Clamps probably don't fully contact the entire Label Area either, as they are considerably dished, because of the design priciple, that VPI uses a Rubber Washer on the Spindle, and has recessed the Platter for the Label. This when clamping down, the entire underside Label Area drops into the Platter Recess, and by proper clamping, with just the right amount of tension (per given LP) the entire underside of LP will completely. and properly couple to the Platter. The exception being, a LP with a odd-severe Lip Warp, and this was no doubt (one of the reasons) why Harry came along with the Periphery Clamp.

As ttweights I think mentions, and perhaps others, that they try to engineer thier non threaded weights to be most effective in coupling an LP to Platter, but this I feel is a very tough thing to do, to find one single non-clampable Weight that will properly work for all LPs due to variable warpage, and variable record weight (140g-180g-200g).

Collet Style, like the Michell might work fine, but there's the possibility (I'm not saying the Michell will, I'm not sure?) of marring-scratching the Spindle itself? Mark

The Music Hall clamp shouldn't continue spinning (and causing label wear) as you clamp it onto the record label. It's a two-piece design and the actual clamp disc shouldn't spin as you turn the locking knob down. Try bending the spring clip slightly to reduce the friction force between the clamp disc and locking knob.

I continue to use the lightweight clamp provided because I'm not sure what the long-term wear on the bearing might be using a heavy clamp or weight.

The disc doesn't need to have much surface area. The idea is to apply just enough circular pressure on the LP to couple the LP to the platter or mat. And not too much pressure. I found that too much pressure creates a dead sounding LP using a foam mat.

Tom

The Basis clamp I had worked very well. Not cheap.

I just bought the TTweight clamp off ebay. For the price it is great... The bottom is dished though...