2. analog
  3. 1233943909

VPI Scout- motor pops in speakers when turned off

I just recently purchased a VPI Scout. Whenever I turn the motor off to change records, a loud pop comes through the speakers. I called VPI about this, and was told that it is "system dependent" and not something to worry about. I was told just to turn the volume down before turning it off, which doesn't really satisfy me as a legit answer. I have read on the forums on Audio Asylum that I am not alone with this issue. Is VPI's response just side stepping the issue? Is it really something to worry about? I found it sort of a lame response.
mekong56
mcdonald43
52 posts
 
I have exactly the same problem. I believe that there is a snubber circuit there but not a very effective one. I just hit the mute switches on the preamp prior to turn off.As far as the belt screech problem, I solved it by placing the belt in a bag (ziploc) of talcum powder and shaking it.
FWIW
dobermann
17 posts
 
> Sns

> I also have screech at startup, belt slipping on pulley, any fixes here?

On my P3 to avoid that i just swing gently the platter by hand and switch the motor on. The TT start smoothly without any belt wear.
atmasphere's avatar
atmasphere
11,793 posts
 
Usually a 0.01uf 600V cap placed across the power switch terminals is all that is needed to deal with this problem. That cap should not cost more than a dollar... we have them if anyone needs them.
arnold_layne
141 posts
 
I get this as well on my Scoutmaster. I just turn off my phono pre between record changes to avoid the problem.
cerrot's avatar
cerrot
1,700 posts
 
I wouldn't use the talc on the belt. Used to be recommended over the years but now they found its a no-no. Eats up the belt.
More to discover