Thanks alot guys. These are very helpful recommendations. I will play with positioning tonight and look at adding an isolation tweak.
I am debating an upgrade to my table, and have been hesitant because my system sounds quite good and I'm not convinced that I have my current setup optimised. Feeling that much vibration on the armtube while the motor is running was quite shocking. Eliminating that, and adding the sds I just ordered should give me a nice leap forward.
Thanks again.
Bob
I am debating an upgrade to my table, and have been hesitant because my system sounds quite good and I'm not convinced that I have my current setup optimised. Feeling that much vibration on the armtube while the motor is running was quite shocking. Eliminating that, and adding the sds I just ordered should give me a nice leap forward.
Thanks again.
Bob