Suggested entry path into vinyl...

T_Bone You forgot the countless hours glued to your seat listening to great music... with none of that listener fatigue!

Cmalak If you want to spend a little less in the beginning try a top MM cartridge that you can get for around $ 500, if you want to get good quality from a recognized MC you will need to spend well over $ 1k plus a better phono stage...JMHO
MM is easier on the tone arm and on the phono stage.

Later on you can get an SV1 or a colibri....

MM cartridges are a great place to start. Many fine ones out there. There is an entire thread here on Audiogon discussing MM cartridges started by Raul Iruegas who IMO is a good source of information on cartridge tonearm matching. He sure owns enough of each and he has tried more arm/cartridge combinations than anyone I know.

Dealers should be able to demonstrate well match analog rigs, but some don't take the time to go through the process. For most dealers vinyl is not a priority. Even though I've had some good dealers available to me who knew analog rigs, I found it best to talk to some of the folks here on this site or use resources at other sites like Vinyl Engine. Lots of information out there. Exercise a little patience and you will do fine setting up a reasonably priced analog rig that will exceed digital play back quality.

Thx Clio09. I got the same advice from Samhar offline on the use of MM cartridges. He also recommended battery powered phono because of the lower noise floor which is so important in vinyl application. Thank you all. Great stuff.

I said med output moving coil so a lower db setting could be used in the phono section and the hassles with amplifying extraneous noise in a beginning system wouldn't be a big problem.

Hi Samhar. Absolutely right. I misspoke. Thanks all for your continued advice. Appreciate it.