xlr vs rca


I understand it is better to used balance interconnects if possible. Is this always the case? Furthermore, if one modifies an rca cable with something like Cardas adapters at each end will it perform as well as a cable that was originally terminated with balanced connections? Thanks for any input.
128x128jamiek
It is not always the case. It depends on the interconnected equipment and on the electromagnetic noise in the environment.

Kal
Balanced is not better because it is "balanced" but beecause so many rca's are really bad conncetion wise. Balanced sounds worse to me in many cases, but I prefer the sound of XLR's to RCA's. A contradiction??? No, I use pin 1 gnd, and pin 2 +, and avoid pin 3 and use the XLR's. Balanced cable is good if it is shielded, and you have a long run, say more than 10M and a noise issue. No noise issue, no need for balanced cable. I like the no 3 pin setup best. Jallen
Dear Jamiek: What make a balanced unit is not the interconect cables but that the electronic audio link ( item ) was/is designed in balanced way.

There are units that are fully balanced ( input to output ) where you need a balanced cable at the input and output ( not because it comes with XLR ), this means that the cable internal configuration and connection to its XLR termination connectors are true balanced.
There are other units that are a only output balanced design with unbalanced( RCA ) inputs.

So it is not the cable termination the one that tell you if it is balanced or not but the audio electronic item internal design.

One advantage on balanced designs is that noise/distortions canceled between the balanced design.

So you don't have any advantage if you use XLR connectors in a unbalanced audio elewctronic item because this item accept only unbalanced audio signals.
Rauliruegas's statements confuse the issue. A completely balanced design component has some advantages over single-path designs but it is not necessary to accrue the advantages of balanced connections. Balanced connections, with their increased immunity to induced noise, require only a balanced output connected properly to a balanced input.

Kal
Jamiek,

If you use XLR to RCA adaptors on each end, the XLR cable in the middle will be performing just like a RCA cable. You don't get any noise cancellation property of a XLR cable. There is absolutely no benefit to do that except higher cost.