Replace VPI TNT rubber belt with nylon thread

Thanks to both. Advice is very helpful.

I use non-flexible nylon string with speed contoller. I find the speed is 6% faster with the nylon string. For the sound, I find it cleaner with less coloration (or less rubber belt sound), tone is more natural, image is 3-dimensional, bass is better defined and improve tonal balance a lot. Exactly what Sojs commented. The background sounds quieter and darker, probably due to more stable speed and no motor vibration is being transferred through the belt to the platter.

But I get small motor noise comes out from the motor spindle. I don't know why. Is the tension too tight? Can this be resolved? Really apprieciate is Ptmconsulting or Sojs can give advise.

San

The string shouldn't be overly tight. Just enough to keep the slack off and make the platter spin. too tight and it seems to constrict and over-control the platter. Let the mass of the platter do its thing.

I have the TNT with the single fly wheel. Should I try replacing just the big band or both?

Do both spans. The short length between the motor and the flywheel likes more tension than the platter span. Heavy cotton or poly thread requires a bloodknot; thicker silk requires a loop knot with the knot positioned to travel on the outside of the span. It takes a bit of practice to arrive at the correct tensions, but once there you won't go back.

I own a VPI Scout and my dealer recommended replacing the rubber belt with a silk thread when I was buying it. Since I don't have a speed controller, would you say it'd be pointless to do it and better to stick with the rubber belt?