Rega 700 rewire

I highly advise you to change the stock wire in the Rega "700" arm. I'm sure Rega still connects the ground to 1 of the signal path wires. I have a 1000 and changed the wire. Pick one of the aftermarket wires, Cardas-Discovery-AudioNote. Any one of them is better than what you have now.

Birdmanpa, I am not a historian but there was some kind of
'Ancien Regime' in the 1970's. Ie the regime of MM carts.
To impress your mates you needed,say,an ADC 25 or Shure V-15. The aim was to get at least 90 Mu, without any buzz in the R channel, from your test LP. You also needed those fragile tonearms such that you was not allowed to breathe
near them . Otherwise you needed to adjust them again.
'The revolution' was caused by SUPEX 900, an MC cart. And since then nobody wanted to be in any way 'associated' with
an MM cart. Only some 'decadent bourgeois' persisted in using them. Probable because they were not able to afford
an Supex.
The 'contra-revolution' started exact on 01.15.08 in our
Forum and was caused by an descendant of E.Zapata. We call
him 'comrade Raul'. You must be a new member because each
and everyone else is ,eh, familiar with the thread about the MM carts. As novice you should read the whole caboodle.
I personaly think that 'comrade Raul' only reestablished
the 'Ancien Regime' but because I like him very much I prefer to use 'revolutionary language'.
Regards,

Regards,

Reb1208, The ground wire one can change for $1. Onscrew the pillar plug,onsolder the ground from the left(?) channel and extend the ground wire from there.One will need
an small hole in the pillar plug to extend the wire. But one can of course pay $150 to $250 to somebody else to do this job for him.

Regards,

Nandric,

Being that you appear to have DIY skills, then just install a DIN at the base. You can keep the internal arm wire as that is the least detrimental to the signal in stock form. Its the Klotz co-axial that absolutely has to go.

As you are mistaken about my skills, Reb, re DIY soldering and wiring, I am having Galen Carol in San Antonio, do a re-wire, with Cardas/Incognito as he has done tonearms for me before and is very good. I have the ability to take TT's apart, and even get them back together occasionally, but I draw the line at wiring. I was tempted to trade up to the P9, but it is very expensive and I can always do it after I have spent some time enjoying the work I have recently done, platter, counter weight, now the wiring, Rega wall mount. Now I only need to find the best cart, for this TT and the EAR 834P Phono Pre. I am about to take some time and advice from Nandric and go back and catch up on the MM/MC revolucion. I own an old Supex 901 Super and think it's great, but I am always looking for somethin better and improvement, I just don't seem to always get it by opening up my wallet.
Thanks to all of you.