VPI HRX

Tuesday to Thursday is the way to go. Check with Harry? That will be the day, he is long gone with the junior in charge. Hey, all high end players work only two or three days a week, that is why they need to charge mega bucks.

thanks Stanwal, i agree with you, i just stick with original

Graham will cut a hole for you to mount his arm last time I checked, but cost of this service is quite high due to large amount of metal VPI uses in the plinth. If I recall correctly, it's in the neighborhood of $500.

If you ask VPI, they will question why you want to go down that route since they are confident JMW 12.6/7 is equal or better than Graham Phantom II.

Buconero - I have no idea where you got your 'tude, but I have had NO problem speaking with Harry at VPI. He is at work every day and offers exceptional help and guidance for his customers.

If you truly want to go with the Phantom Mk ii and the HRX, that is your decision. FWIW, I consider the Phantom Mk ii the best non-table specific pivoting arm made. If yes, I would suggest you contact VPI and speak with Mike.

I recently mounted a Graham Phantom Mk ii on my TNT Mk IV using a Bob Graham custom arm board - spoke with Bob directly, gave multiple measurements, etc. While incredibly well made, it did not accomodate the Phantom and Bob's cost for re-machining an already expensive arm board and providing a sub-arm board (yes, it was too thin) was prohibitive.

I called VPI, talked with Sheila and Mike and they offered to machine the arm board FOR FREE - I just had to pay shipping to/from and of course buy a very reasonably priced sub-arm board. They offered to machine something that wasn't even their arm board! I made a donation to their foundation as a show my appreciation.

You cannot go wrong working with VPI. Very good people.

Brent