Does phono stage noise drive you crazy too?

I had the same problem with my Grado Statement Sonata1 using the Grado PH-1 preamp. Reading this thread was like having a deja-vu. My (short story) solution was to upgrade the op-amp in my PH-1 from the NJM4556A to 2 x OPA627's mounted on a Browndog single to dual op-amp adapter. I tried other op-amps (opa2134, opa827) and found opa627 to be superior. It was clearer, quieter and more dynamic at high output with barely any hiss. In addition, I bypassed the PH-1's output coupling caps with 0.1uf micamold pio. Now the sound is as dynamic as anything I have ever heard and I have to put my ear to the tweeter to hear any hiss. I am finally enjoying this cartridge.
I tried using Hagerman's piccolo moving coil step up amp but that didn't work out. I'm told you can't use a MC step up transformer with a MI cartridge, so I didn't bother. My tube phono stage didn't have enough gain either. Now I was starting to understand why people preferred moving coil cartridges; their low outputs can be stepped up quietly without using an active stage (which adds hiss). IMO, the statement series needs at least 60db gain with no hiss to be enjoyed, and I wasn't going to throw good money after bad searching for another phono pre. I contacted Grado about the issue and got this kind of reply: "??? what are you talking about?". Their most useful suggestion was to reposition the phono stage, which I had already done with of course no effect. Here I was using a Grado cartridge with the Grado Preamp and the hiss was annoying the urine out of me. If I hadn't accidentally blown out my PH-1 necessitating it's repair, I would have never stumbled upon a solution.
Good luck, I hope this helps.

Not really.

I thought I'd post an update. After doing a bit of further research, I thought I'd try something a little higher up the audio food chain to see if a more compatible preamp with low output Grados could be found. A couple of emails later and I had one of RCM's Sensor Prelude phonostages courtesy of Mehran at Sorasound headed my way. After living with it now for a few weeks, I can say this has been one of the best audio purchases I've ever made. It took what virtues the Acoustech PH1-p had and expanded upon them, added tonal density, and does everything with much less background noise. It's a truly excellent sounding product that balances insight and soul. Using the Grado Master at similar gain settings with the RCM and the Acoustech proved once again that while specs may be similar, numbers don't tell the entire story.

Yes, even if I can only hear it when nothing is playing.

The two types I have had to deal with in practice in recent years is EM and hiss from noisy or aging tubes.

EM inducted noise really bothers me and I have zero tolerance. I suspect it affects sound quality even at levels not easily heard in practice. Mu-metal shielding around my step up device was the solution. Hiss from noisy tubes can also bother me but not as much.

My Manley Steelhead is quiet as the grave. Love it. Not sure if you have tubes in your setup but when I first received my Manley amps one of the input tubes had been damaged during shipping and produced some noise similar to what you are describing. I swapped out the tube and POOF no more problem.

PMB