Help Classe CA300 flashing Green Light


Ok, I am no techie and on my own since my husband is traveling this week.
so tonight, I poured a glass of wine, made a fire, turned on the HT, put in a movie and.....
my Classe CA300 goes from blinking red to blinking green and never works.
It was working fine just the other day - no changes to setup.
The manual is worthless.....
any ideas?
Thanks in advance,
Angela
angela100
Angela, I own a Classe as well, and this has happened to me on rare ocassions. What I did is turn it off, wait a few minutes, and turn it back on. It will cycle through (red light blinking) and then you should hear a "click" and everything should be OK. I agree with you--the manual is pretty worthless. Hope this helps, Jeff
Angela,

You might want to check and see if any of the speaker wires are shorted. This will cause the amp to go into protection mode.
Good luck.
Angela, i've had a ca200 for about 5 years and mine used to do that often and then mysterioulsy hasn't for years. that is the protection circuit kicking on, i'm no techie either but the bias on those amps is very high which can cause it to clip or overload with no signal so i'm told blah blah blah. However, it always reset itself if you follow instructions above and power down and then cut back on - it always worked for me.
thanks for the tips so far. When I get home from work today, I'll go through so more troubleshooting. I was just sick and tired last night and ran out of patience. I just wanted to "relax" and escape with a movie....
one more piece of data-
when I turn it all on without actually playing anything through the speakers yet, the Classe cycles - blinking red then stops at a solid red (how it is supposed to work).
If I change the preamp from the digital input to the radio, the Classe is fine and the front speakers work.
If I change the input to digital and try to play a CD or DVD, then there is a "pop" and the amp blinks green and is not working.
that's telling me that the speaker cables from the amp to the speakers are ok, right?
Isn't is also telling me that the digital input is ok, since the other amp and speakers play.
Are we down to the IC's between the preamp and amp or the physical connections on the preamp or amp?
off to take a shower and get in the rat race....
thanks to all
Where is your amp located (rack, wall unit, floor)? I used to own a CA-100 and have experienced this problem. The amp was kept on the floor. After some investigating, I determined that when someone walked on the carpeted floor, enough static electricity was produced to engage the protection circuitry. I then placed the amp on a dedicated amp stand, and the problem disappeared. Perhaps something similar is happening. Try contacting Classe. They are usually very helpful. Good luck.