You didn't mention results of different load settings on the PS Audio. Also, because there are two gain stages, you need to tweak them to find the sweet spot. You should be able to make it sing without a pre-amp, if not it's something else in the chain.
Dialing in my analog rig - Need help
I took a giant leap forward in sound quality this past weekend after deciding to check the setup that was provided by the dealer. Hell, I watched him and thought he covered everything. I was largely unhappy with the sound of my newly acquired rig. I am now only slightly unhappy as I discovered the following.
Being that it was a used Turntable/cartridge with no manual I downloaded the manual and performed the following. What I found was that my cartridge was way out of alignment according to the jig provided by VPI. That was a painless fix I than checked the levelness of the tonearm as it pertains to the platter. What I found was that the tonearm was set (or never set) all the way at the bottom of its adjustment. Doh! So I cranked that up to "level with platter". Was that how former owner had it set? Then there was the alignment of the head shell and of course that was off too. Now I was on to the tracking force which I defaulted to slightly more than 2 grams. The gauge I have is kind of crude compared to what the dealer was using but then the dealer seemed to miss a few items anyway...
As I mentioned earlier in this post, although being very unhappy it has gotten a LOT better. Many smiles have practiced over the last few days but one thing that still plagues my setup is the graininess or lack of smooth sounding highs. It's detailed as hell but vocals still have a "grain" to them. Nice staging and a goodly amount of air. I just seem to lack the smoothness I thought would be natural to vinyl.
Setup is;
VPI Scoutmaster, Dynavector XXV Mark II which feeds a PS Audio GCPH phono stage then direct to a Pass Labs amp. MBL 121 speakers. No preamp yet - still looking.
What's next?
Being that it was a used Turntable/cartridge with no manual I downloaded the manual and performed the following. What I found was that my cartridge was way out of alignment according to the jig provided by VPI. That was a painless fix I than checked the levelness of the tonearm as it pertains to the platter. What I found was that the tonearm was set (or never set) all the way at the bottom of its adjustment. Doh! So I cranked that up to "level with platter". Was that how former owner had it set? Then there was the alignment of the head shell and of course that was off too. Now I was on to the tracking force which I defaulted to slightly more than 2 grams. The gauge I have is kind of crude compared to what the dealer was using but then the dealer seemed to miss a few items anyway...
As I mentioned earlier in this post, although being very unhappy it has gotten a LOT better. Many smiles have practiced over the last few days but one thing that still plagues my setup is the graininess or lack of smooth sounding highs. It's detailed as hell but vocals still have a "grain" to them. Nice staging and a goodly amount of air. I just seem to lack the smoothness I thought would be natural to vinyl.
Setup is;
VPI Scoutmaster, Dynavector XXV Mark II which feeds a PS Audio GCPH phono stage then direct to a Pass Labs amp. MBL 121 speakers. No preamp yet - still looking.
What's next?
- ...
- 51 posts total
- 51 posts total