VPI 10.5i - Which armwands do I own?

You say the one with the "slanted" azimuth ring can't be adjusted. I have one with the same azimuth ring, and it's adjustable. Did you loosen the two set screws holding it in place? It's still stiff to turn with the screws backed off, but it will move.

thank you vm for your responses

@Stringreen

yes, they are both wired with Valhalla.
I think you are right concerning the stainless steel arm wand; however, the materials used for both arms do not look different at all.
I still do have a vdH Frog, a Benz Micro Wood S L and a Ortofon Cadenza Bronze; started to check which I like most on the arm. At the mom I like the Cadenza on the heavy armwand most.

@Jr_w

the azimuth ring and the upper bearing housing are one piece;
no set screws.

@Bifwynne

thanks, I will contact VPI

Helmut

Mike told me that they make SEVEN different counterweights for these arms. Check yours. The bottom one must have a heavier counterweight than the top one. I have three 10.5i arm tubes, all different, two with 115g counterweights and one with 140g. I really can't imagine why the bottom arm tube has an immovable azimuth ring. What would be the point, if it can't be used to adjust azimuth?

You should use the off center rear counterweight to adjust azimuth. When adjusting, the bottom of the weight should be moved to the higher side.

Well sure, Stringreen, but that means every time you adjust VTF you have to RE-adjust azimuth .. and then readjust VTF ... etc. Much simpler to use the azimuth ring in the first place.