the actual bearing shaft may be slightly bent. How did the damage occur. was there an impact to the platter or bearing? Getting that shaft straight may be a problem. Is it one side that is consistently lower than the rest or is it random? Are you using a bearing that is the same size as the bearing shaft, or something smaller?
Audiomeca Romance
Hello dear Audiogon forum dwellers,
I have an Audiomeca Romance turntable. The tip of the piece which is in the sleeve of the platter is extremely damaged(do not ask how :). I think because of this the platter is now destabilized and is oscillating badly. I hopelessly need the measurements of this piece. Indeed the length is enough, I think.
The piece I refer to can be seen on the diagram of the Audiomeca Bella turntable below. It is just above the heart.
http://www.tnt-audio.com/jpeg/bellacutaway.jpg
I tried to contact Mr. Pierre Lurne with no success.
Any help is extremely appreciated.
Thanks.
I have an Audiomeca Romance turntable. The tip of the piece which is in the sleeve of the platter is extremely damaged(do not ask how :). I think because of this the platter is now destabilized and is oscillating badly. I hopelessly need the measurements of this piece. Indeed the length is enough, I think.
The piece I refer to can be seen on the diagram of the Audiomeca Bella turntable below. It is just above the heart.
http://www.tnt-audio.com/jpeg/bellacutaway.jpg
I tried to contact Mr. Pierre Lurne with no success.
Any help is extremely appreciated.
Thanks.
- ...
- 12 posts total
- 12 posts total