2. analog
  3. 1323729715

Audiomeca Romance

Hello dear Audiogon forum dwellers,

I have an Audiomeca Romance turntable. The tip of the piece which is in the sleeve of the platter is extremely damaged(do not ask how :). I think because of this the platter is now destabilized and is oscillating badly. I hopelessly need the measurements of this piece. Indeed the length is enough, I think.

The piece I refer to can be seen on the diagram of the Audiomeca Bella turntable below. It is just above the heart.

http://www.tnt-audio.com/jpeg/bellacutaway.jpg

I tried to contact Mr. Pierre Lurne with no success.

Any help is extremely appreciated.

Thanks.
monolit
monolit OP
5 posts
 
The bearing shaft is not bent, but the tip is crushed. I have had one replica made by my friend who works at a lathe. But there is a problem with the height I guess. Because the tip is crushed it is impossible to know the exact size. We made it approx. the same size.

The side that is lower is random. And I am not sure of the bearing. There was no bearing. Is it possible that it is bearingless model. It spins on top of the tip?
manitunc
795 posts
 
Here is a paper by Pierre Lurne, the designer of the turntable that discusses his bearing. I think that you have to get the right taper on the point of the shaft or it will be able to move on the seat. How high off the plinth does the platter run?
http://www.enjoythemusic.com/magazine/manufacture/0208/index.html
nandric's avatar
nandric
4,086 posts
 
I owned the Audomeca J1. There is a carmic ball fastened
in the platter. The top of the axle had a kind of hole which centered the 'point' of gravity for the platter. Your machinst need to see and measure exactly the axle by
someone who owns the Romance. With his lathe he should be able to produce the same axle from (hardened) steel. You will also need some grease because you can't use oil for
this bearing.

Regards,
monolit OP
5 posts
 
I've read that paper. Very good intro to how the Audiomeca romance works. The platter runs 11 mm off the plinth.

If I could have found someone who owns a Romance then it would be very easy to replicate the damaged piece. But so far I had no success.

I had a hope that someone using this forum who owns a Romance could help me with the sizes.
monolit OP
5 posts
 
Still no progress :(
More to discover