2. analog
  3. 1333635524

Benz Lp-s Frequency Resonance Problems

Hi to all,

As i mentioned on another thread, i have some problems with my Lp-s on my Graham Phantom arm, i have problems with little warps. I have measssured with the Hifi News Lp and lateral i have between 8hz-5hz and vertical i don't know well as i can't see cartridge wobble or hear any distortion. But for my problem the important is the lateral test.
Benz recommends medium to high mass arms but that's impossible!
To get 10hz frequency resonance you need a 0 gram mass arm!

I don't know if to try a Reed arm, the lightest one is 10gr effective mass and i should have 8hz Resonance frequency.

Any idea?

Many thanks
agucela
bifwynne
2,206 posts
 
Agucela, I have already been down carty/tonearm heartbreak lane. Pull my threads to see my history. My troubles involved matching my VPI Classic unipivot with a cartridge that also resonated in the low frequency range. Ultimately, I worked with the factory and resolved the problem. My suggestion is that you call Graham and possibly Benz and ask for their advice. I'm sure you'll figure something out. Good luck!
stringreen's avatar
stringreen
6,435 posts
 
My LPS is tracking flawlessly in my VPI. I had to get a weight to properly balance it, however, it is beautiful now. I would call Graham and ask them
agucela OP
17 posts
 
I spoke with both,

Graham says that the arm is able to balance it out, and the arm does, but this is not the problem. The problem are the warps because of the effective mass. It is too much mass for this compilance.

And Benz says that i have to try and when it don't work with a arm, then try with another arm. They say that for example, they tried with SME IV and V and measured with the HN Lp lateral frequency resonance was between 9hz-9,5hz.

Mine is at 6,5-7hz, that is too low and i hear it with little warps.
More to discover