Help me improve Rega P2

Thanks, Marty (Viridian). It should be noted, though, that the DB Systems kit, or any other similar kit, can only add capacitance, not reduce it.

But we tend to focus on those things that we can measure, rather than those that we can't.

True enough, in many cases. And I personally have never experimented with intentionally mismatching load capacitance of MM's relative to the manufacturer's recommendation, to see how much difference it would make. But I see it this way: Audio is a pursuit in which many people concern themselves with unexplainable, unpredictable, and often dubious minutiae, even in some cases to the extent of things like which way a fuse is oriented. Given that, why introduce an explainable, predictable, and known inaccuracy into the system, notwithstanding the possibility that it **might** be minor in degree, or perhaps even subjectively preferable? And if it should happen to be subjectively preferable, chances are it is compensating for a problem elsewhere, which ideally and hopefully should be found and fixed rather than compensated for.

Best regards,
-- Al

A Denon dl 110 is a good upgrade. I've seen a Canadian retailer still selling them for 129. I would also look at the subplatter upgrade from tangospinner....as well as the pully. That gets you under 300. Later on you can go with the tonearm rewire from brit audio.

Yes you can greatly improve that table by bypassing the factory feet. Put the table on 3 Cardas blocks, 3 same size cans you have in your pantry, etc.

Thanks Al for the response. I did not go back to the manual and went on recollection, which at my age is suspect. I am sure the ‘below 200pF’ is correct, not 100pF. Anyway, is seems logical that this low value rec would include that added by tonearm wire.