how do you set VTA onthe SME 309 tonearm?

I had an SME V. Included in with the arm is a kind of screw driver that fits that screw. The V works the same way as I remember.

From the two pics posted, it looks like a standard hex wrench with a center-drilled hole to let it slip over the tamper-resisting post in the center of the bolt.

If you can't find one online or from an SME dealer, worst case would be to DIY. You'd need a drill press with work clamp and a very hard bit. Any machine shop could do it in about 2 minutes, including the metal shop in the local high school/trade school. Please wear eye protection!

But really, they should be readily available...

You guys are making this way too complicated...

Not sure where audio779 disappeared to, but if he purchased the tonearm new then he already has the proper hex wrench tool. It's the one with the handle like a screwdriver. If he doesn't have the SME tool then a simple 3mm Allen/hex wrench will work. No center drilling required.

Only advantage to the SME tool is that it has rounded corners for convenience in fitting (and turning) the wrench in the bolt heads. SME (UK) or Acoustic Sounds (USA) or Flat Earth Audio (USA) would be glad to sell him a replacement.

Regards,
Tom

To add to Tom's comments above, the OP never asked about a tool. He asked how to set the VTA of the arm. I bet he already has the wrench. He justed needed to know how to raise and lower the arm post.

Tom even showed him where the screws were in the link he provided, so yeah, this got way over complicated...

But isn't it more fun to visit a machine shop and DIY a wrench you already own? ;-)