VPI setup


I just received my VPI Classic 1 -- 30th Anniversary turntable. Purchased on eBay, which I hope was not a mistake.

This is my first attempt to setup up a turntable. I have read the manual several times, and looked for videos and other sites reviewing setup. The TT has a uni-pivot arm which wobbles a lot and apparently that's just how it's designed.

So I'm playing my first records on the setup and there are two problems.

1. Skipping, even on new records. I have an Ortofon Quintet Bronze (new to me purchased slightly used on Audiogon). I've adjusted the tracking force to 2.6 using the Shure tool included with the VPI. This is slightly over the recommended range 2.1-2.5g. Do I still need to increase the tracking force a bit?

2. Voices are fuzzy. The only vocals I have are on regular vinyl. I do have some Mobile Fidelity Original Master Recordings of jazz (no vocal) and it sounds fantastic. But even these will skip, albeit less frequently.

Neither were an issue with my lesser Traveler and Bronze MM cartridge -- no skipping and no fuzzy vocals.

I've eyeballed for azimuth and followed all the VPI instructions the best I can.

I'm also wondering if given my investment I need to also purchase a good record cleaner -- better than my cheapo Spin Clean. Maybe with this step up to the Classic 1 and the Quintet Bronze it's just sensitive to every bit of dust and flaw.

Suggestions?

System:
VPI Classic 1 with Ortofon Quintet Bronze MC cartridge
Herron Audio VTPH - 2 phono preamp
Cary Audio SLP for linestage preamp
McCormack DNA-750 mono blocks
Vandersteen 3a Signature speakers
van Den Hul and WireWorld Silver Eclipse 7 interconnects
evolving
I know you solved your problem but can't help but add that it is always a good idea to make sure that your arm is properly centered on top of the spike. Just pick up the arm verticallya and set it back down and then carefully check to see that the arm pivots smoothly.
Second, that Shure guage is not reliable. It is amazing it works to the degree that it does but mine crapped out in no time due to the pivots points on the see-saw being worn. Invest in a good digital gauge. Beware of the cheap Chinese knock-offs. Reliable VTF is a must!
Third-you have to make sure your table is level.
I saw a VPI veteran once simply shove a cartridge (my own Benz Glider) into the very front of the headshell when setting up my table very preliminarily and the sound was still quite passable though not optimum-the point being that the degree of problems you had could never have been due to less than optimum alignment.
And last-the VPI unipivots are not the easiest arms in the world to set up. Don't feel the least bit shy about having problems. A gimbled arm with spring set VTF like a Rega or Project are far easier. You dove into the deep end a bit.
yes, the Counterintuitive makes it much easier to set up (I forgot that yours doesn't have one....I have a 3D which is nearly impossible to set up well without it, which is why its included with the 3D.)
Yeah, I'm springing for the Counterintuitive..

And I agree that the Shure scale can't be that precise.

Anybody have a recommendation for good digital scale? I see a lot of pretty cheap ones, but really do want something that will help me drill down on the setup.
The other thing I discovered this morning:

When adjusting the azimuth ring with the screws slight loosened it can start to slide down and shorten the pivot distance.

It took me awhile to realize it had. Thankfully easy to slide back.

I'm really appreciating how simple yet adjustable this puppy is. At least now that I'm a little more relaxed with the setup!
The Mapleshade scale is accurate, reasonably priced and uses (2) AAA batteries (easier to locate, less expensive). Highly recommended!