Hi Dekay. I am using the 47Labs for interconnect and speaker cables. I couldn't stand the idea of running them in separately either. I no longer use any digital interconnects and only need a stereo pair of ICs and a stereo pair of speaker cables in either of my systems. I have not used solid core cables for a while, except that the cables I have been using each use several or many solid cores separately insulated. Given I am getting quite excited by these 47Labs cables I feel I need a reality check with a good solid core cable in case it is just my system context that is causing me to like single solid core cables now, when I did not before.
The impact of twisting the cables is an interesting point. I first ran them untwisted, and the sound was a bit vague, so I twisted them together loosely and the sound tightened up a bit. Later the system was sounding a bit thinned and congested and flattened, and so following Ken's advice I untwisted them again and the sound was better. It is hard to know where the sound of these cables will end up but I feel untwisted is probably going to be better. Very hard to know since moving the cables results in more burn-in.
I emailed Yoshi of Sakura Systems on the twisting issue but his reply was non-committal.
By the way, I didn't have any of the problems you encountered with threading the cables into the ground connectors - which is a little bit odd because we must have ordered the cables at about the same time. I just held my mouth right and gave the cable a shove and it went in.
The impact of twisting the cables is an interesting point. I first ran them untwisted, and the sound was a bit vague, so I twisted them together loosely and the sound tightened up a bit. Later the system was sounding a bit thinned and congested and flattened, and so following Ken's advice I untwisted them again and the sound was better. It is hard to know where the sound of these cables will end up but I feel untwisted is probably going to be better. Very hard to know since moving the cables results in more burn-in.
I emailed Yoshi of Sakura Systems on the twisting issue but his reply was non-committal.
By the way, I didn't have any of the problems you encountered with threading the cables into the ground connectors - which is a little bit odd because we must have ordered the cables at about the same time. I just held my mouth right and gave the cable a shove and it went in.