DIY cables Vs Mass market cables.

Pabelson, your cynicism shows, but I agree with you.
My DIY Canada Wire 12ga Red Heater wire, non terminated, sound the same as the 16ga lamp cord that I previously used.
Bob P.

pableson, you have hit it right on the head. I have tried them all. Good DIY is as good as anything 1-2 I have tried. Plain and simple and will blind test them up against anything.

Bob P. plug in an Analysis Plus Oval IC and you will get better sound than your lamp cord or DIY wire I imagine. This thread is turning into - it's better/it's not better and I don't think I have more faith in DIY or less. So, nice thread, but the question will still remain. It's been fun though.

Rob

When you say satisfactory, does that mean they will better JPS labs or Analysis Plus cables

It would depend upon the system. The effort in commercial products goes toward achieveing "good" sonic results in different systems. WIth a diy solution you're aiming at getting "good" sound for the specific application (i.e. your present components).

For example, my copper diy's IC connecting the amps, sound slightly better overall than an expensive silver commercial offering. The same cannot be said for other systems (where the commercial offering is slightly better).
Mind you, however, my main amp has a very low rated input impedance which allows me to use unshielded (if short) ICs... Cheers

Robm, 'you will get better sound than.....your DIY wire I imagine' surely that is a Freudian slip. Of course you are 'imagining' the 'better' sound.
With respect, Bob P.