Synergistic New Tesla Line...Any comments?

Someone asked about the Powercell SE's dimensions. I took the measurements and here's what I came up with:

- 451mm (17.75") width
- 362mm (14.25") depth
- 140mm (5.5") height

Joeyboynj, I have all of my SR power cords plugged into the PowerCell leaving room only for the charger of the PC cord and PC and for the T2 that leads to my QLS-9, all of whose outlets are occupied by MPCs. As I have said behind my rack is a rats nest. What neatness I had was lost when I changed to the StillPoints rack. I ardently hope for a new Enigma in the near future.

I hasten to tell everyone that the PowerCell itself greatly improves with isolation feet beneath it. Try Migs there or other feet, such as StillPoints, and you will not go back.

---> Airportsyndrome

Thank you very much for measurements. I have asked about it.
You have done what was impossible for other users and even for famous Synergistic Research customer service…
Thank you once again.

*********
01-26-10: Shellie
I was visiting the SR factory today to see and hear the new Galileo cable cells (amazing). While I was there I asked Ted about Bacardi's idea for an Active HDMI cable and learned that Ted already has one at home. Long story short Ted went on to post the basic gist of our conversation to this thread not realizing that I was already logged in on his computer. I apologize for any problems this may cause and hope people will understand.
***********

This, right next to a message sent by Ted on the same day giving some advice..... under the name and nick of Shellie... You can check a few posts back if you missed.

So now, how many of you think Shellie and Ted are the same person?

Makes me wonder how many other posters could also, potentially be SR staff...

Not saying anything. Just does not look too good. Check Shellie's answers on this site. Not too many interest beyond SR products.... Strange at the very least. So Am I being overly suspicious, or others also think there could be a case of double personality here.

I'd posted this as a seperate thread and didn't get any responses.

Teslaplex and outlet covers? Anyone experimented?

The Oyaide is a bit too expensive for me.... but furutech has a carbon and brass cover and Acme has a really beautiful Ebony wood cover... then there's all the other various plastic, stainless, brass, etc.

Anyone played with these with their teslaplex?

thanks!