Synergistic New Tesla Line...Any comments?

I don't think there's a weight limitation on the MiGs. If there was one it would be well documented. Last time I checked the manual that came with the MiGs did not have a weight limitation clause.

But I would implement common sense on their placement. Make sure that they are placed in a triangular configuration with proper balance.

Maybe Ted might want to include some kind of weight disclaimer for liability purposes but that's up to him.

Airportsyndrome, just try it. I would be more concerned with what is under the MIGs.

Scottmac62, my solution that works is to move PowerCell to the back of the shelf. I have found the PowerCell sounds better on the MIGs rather than on my Mana stand. It is in the area of sound stage realism and dynamics.

It seems like you already tried it Tbg. Ozzy's amp weighs 150 and you weigh 190.

Yep the concern is what's under the MiGs and the way they are positioned under a component. The manual says to place the MiGs under the HEAVIEST section of your component.

The MiGs are like arches on a bridge and are capable of supporting heavy loads.

Thanks for the help. Presently my 150 lb Amp sits on a 4" block of Maple with a high gloss black finish.
Under the Maple is (4) 2" threaded Audiopoints.

I will try two of the MIGs in the front and one in the back. I hope the MIG's dont dig into the Maple.

A couple of suggestions with the Powercell is to place Mrytle blocks under the MIG's. Of couse only after all your power cords have been attached. That way the MPC's will clear the bottom.

Another idea is to use little jumper cords designed for the wall wart plugs. They will allow you to plug the short jumper into the Powercel and the MPC then into the jumper.

Tbg, thanks for the advise, but unfortunately this is not
an option for my rack since there are support posts in the
way. So, did the increase in sound stage come at the cost
of increased edge or brightness?

Ozzie, does SR offer these jumper plugs, and are they
quantum tunneled?

Also, I would like to know if any of you have achieved
a relaxation effect using the migs.