2. cables
  3. 1173454771

Anti-Cable High Frequency Performance

I've just installed a set of anti-cables in my bi-wired system with Magnepan 3.6 speakers. I find the bass and mid-range nice and tight and the overall sound very balanced, smooth, and natural. The soundstage is very good.

But I notice that the high end is not as extended as my previous cables (good quality oxygen free heavy gauge copper strand). There's less detail in the upper end.

I did twist the anti-cables as directed in the instructions to get as much high end performance as possible.

I like the natural sound but I miss the high end definition.

Has anyone else had a similar experience?

Or, does anyone have any advice about alternative cables at the same price?

I should say that I am very impressed with the overall quality of the sound. This is not an anti-anti-cable post. Just trying to tweak it some more.
selmeralto
nrchy's avatar
nrchy
2,124 posts
 
I still have a set in my office system. I think they sound JUST OKAY at the very best. Very little on the bottom and top end...

Just another bunch of cheap cable hype... you can do A LOT better...

O

o

.
mrtennis
3,295 posts
 
i have a twisted pair of the anti cables. there is no loss of treble extension at all. if anything, there is too much treble emphasis.
kevine
38 posts
 
I have a set of these cables that I have used with a four amp system. When I first received them, the cables sounded really nice, but then I went and replaced the 14 gauge amp power cords with 10 gauge cords, which extended the bass, I lost the last bit in the highs--the speakers sounded muted. I replaced the cables going to the high frequency drivers with a lower 18 gauge generic cable, actually stripped some old audioquest cables down, pulled out two of the wires, made my own cables, and have my highs back again. I left the ant-cables going to the low freqency drivers alone and am very happy with the set up.
selmeralto OP
2 posts
 
In the interests of fairness I should say that I have discovered a mistake I made while installing the anti-cables. I had accidentally hit the bridge switch on one of my amps while installing them. That was why the sounds got garbled. I put the put the switch back to the unbridged position. The anti-cables now sound very good. Sorry for the misleading post.
tbonedeluxe
38 posts
 
I've got a couple of sets of anti-cables. While everything seems system dependent, I think you'd be nuts not to try them. They work wonders in my system. More transparent, very widerange, and much less 'there'. For the price you can always send them back or sell them, but I think you'll be pleasantly surprised.

I'm using them to bi-amp my VR2's with an NAD M25, and they've never sounded better.
More to discover