2. digital
  3. 1389497973

Length of digital cable?

Picking up where I left off a year ago, somewhere on the net I ran into a recommended length of 18 ft of digital cable between transport and D/A converter. Various lengths were discussed and one source was very confident of the 18 ft length to successfully resolve jitter. And the Beldon 1694A was recommended. For $30+ or whatever I gave it a shot and was surprised by the quality of sound, and I swear on a stack of owners' manuals that this length with this brand of cable resolves jitter. The sound is rock solid gorgeous.

The Beldon lies behind the system mostly in a coil, and I think coils are probably not ideal. I'm wondering if anyone has found a shorter length that works. Al suggested 8", but I was unable to make it work because the components aren't close enough. I know that 1 ft" doesn't work and that 1 meter doesn't work.

Part 2: Does length of ethernet from computer to avr also affect jitter? My sister who is a computer person and not an audio person set up my avr with computer using cat 5. The sound quality is bad. I'd like to get good sound quality with computer as source down the road but need advice on how to get it.
arnettpartners
almarg's avatar
almarg
9,670 posts
 
Hi Lynne,

I have no thoughts about the HK990 issue.

Regarding the ethernet cable, I can recall a couple of members here whom I consider to be particularly credible reporting that upgrading their ethernet cables to SHIELDED CAT6 resulted in significant improvements. It wouldn't cost much to give it a try. Newegg.com is a good source.

The likelihood of that providing a benefit may depend, though, on the shielding (if any) and other characteristics of the mating jacks.

Best,
-- Al
arnettpartners OP
312 posts
 
OK, Al. I'll try it. Thanks. Best, Lynne
audioengr
3,282 posts
 
HK990 issue was likely a ground-loop issue.

One must take care to use the optimum AC outlets and circuits for digital, particularly when the devices don't have galvanic isolation from each other. Never use two different phases from a panel and best to use the same circuit for all devices.

Steve N.
Empirical Audio
arnettpartners OP
312 posts
 
I was using separate circuits for digital and analogue. That is, transport was on separate circuit but was using the amp's onboard D/A converter. I do have all components on the same circuit in the basement.

I would like to try your cable. Will get in touch.

Thanks.

Lynne
audioengr
3,282 posts
 
"I was using separate circuits for digital and analogue. That is, transport was on separate circuit but was using the amp's onboard D/A converter."

That could easily do it.
More to discover