Do I really need a preamp?

When researching SS amps to go with my current ARC tube pre-amp, I found a surprising # of leading contenders otherwise with 10Kohm input impedance or not much higher, especially older models. The trend in more recent years might be different,perhaps due to popularity of tube pre-amps with audiophiles.

Most that mentioned design for use with tube pre-amps tended to be in 60-100kohm range, unbalanced, double that for balanced.

Mapman, then does that mean if my solid state amp has an unblanced input impedance of 47K ohms that it is not compatible with a tube preamp?

Any input impedance is "compatible" ie it will work. Its more a question of how well. The 10X rule is commonly cited. That's a reasonable approach, the challenge being that impedance can vary widely at different frequencies and a single output impedance rating may not reflect the worst case, so I think it best to include some tolerance as an insurance policy whenever in doubt.

47Kohms is most likely a good match in general. I would not be concerned at all if everything else looks good. I cite 60kohm merely as a very safe number to go by in most any case based on what the vendors seem to commonly go for when designing towards the goal of compatibility with tube pre-amp gear. Higher input impedance is pretty much always as good or better for best results in regards to low distortion, detail and dynamics.

YES it is the heart of your system

We really ask alot of that litle potentiometer in that preamp of ours. We put the whole audio signal through it and ask it to attenutate just what we want, just the way we want it too. We want it to bring us the emotion, without any distortion. We want to be able to hear the quiet, and unravel the loud. That is a tall order and you really (REALLY) need a higly resolving preamplifier (unless you have an aeris, etc, ie a dac that has some real archectecture behind the volume control)to pull it off. Some live perfomrances can benefit from a good preamp.