single ended cable crossed at bi wireable speaker?

Douglas, unfortunately, my AQ is 8ft and cannot cut it to run separate cables from the same wire. I have to either buy another cable or re terminate. OR get a really good set of jumpers using bare wire as this is supposed to sound even better than bananas or spades? Replacing the jumpers seems the cheapest and easiest upgrade at the moment. I have access to AQ rocket 44 that i can open up and just use the copper conductors without the cumbersome nylon jacket. The manufacturers make a strong point about directionality, but i think this is critical when taking advantage of the +&- geometry in the guts of the cable with a longer run. Not so much with 8cm jumpers. I'm really happy with the sound I'm getting at the moment, two nights ago I moved my speakers a few inches in and the sound has opened up incredibly. So much so that i completely forgot about this thread and my cabling dilemmas hehehe :)

Nonoise, Im also interested in experimenting with speaker cables and using different properties of materials to tweak the sound in a biwire setup. The pdf I posted initially, though, has an interesting point. With a speaker with just a couple of posts, the crossover between bass driver and mid woofer is bound to happen somewhere where critical music information is being reproduced. Introducing different inductances and resistance of different cables can compromise the coherence of a melodic line or the tone of a male voice. As exciting as the tweakers route can be, this doesn't seem a desirable scenario. According to audioquest you should give utter respect to the midband by using exactly the same wire type to biwire.

Audiopanda,

I understand where experimenting with speaker cables of differing properties can negatively affect the sound where the crossovers are but in my case, I have Tonian Labs TL-D1s which use a Lowther widebander with a customized Raven supertweeter that covers the uppermost frequencies so that critical 2K region is unaffected.

Lucky me.

But by all means, do experiment and trust your ears. One doesn't have to go exotic and spend lots of money. In my case, I had some time on my hands and simply experimented with some older cables I had laying around and simply lucked out on the results.

Now that I've had success with the bi-wire approach, I'm going to try out a double run of the Helixes to see if they better what I've gotten so far, when the urge (demons) get the better of me and my pocketbook.

All the best,
Nonoise

Audiopanda, my experience has been that jumpers of any sort are inferior to double sets of cables in parallel.

Douglas, the only thing im slightly concerned is that using double runs could increase the bass prominence, which I really dont need as there is a bump in the 40hz region. Could you elaborate a little on how the sound differs when using double runs? Sorry to be a pita, but getting a similiar cable would be well over $800. And my dealer doesn't have one to demo.

Audiopanda, all frequencies are influenced, not only bass. The only way this would perhaps be a problem is if the cables emphasize the bass in the first place. Then going to two pair would give more of that effect. Usually if you like what the cable is doing then doubling will give you more of what you like.

So, if you do not want ANY more bass at all than what you have now, the answer is yes, you will get more bass presence. But you should also get more Mid/Treble too, and more clarity, and more 3-D soundstage, etc.

I would assume that running two pair you will have the same bump in the 40Hz region, only the bump will be more beautiful sounding. I'm only half-joking. :)