Tonearm wiring termination---DIN, or RCA jacks?


I'm about to get a tonearm rewired, and am curious how ya'll feel about the question of whether 'tis better to terminate the arm's internal wire into a DIN connector at the bottom of the arm shaft, or into RCA jacks mounted in a block such as Cardas offers, into which RCA cables are inserted.
128x128bdp24
In a related matter.....In looking for a new phono amp, I've noticed something: the location of their input jacks seems to be chosen for reasons of circuit board layout rather than of where the best location ergonomically is. I have my phono amp directly under my table, and the best place for the input jacks of an amp so located is obviously on the far left end of the rear panel (looking at the panel from the rear). So located, the arm wires need be only long enough to reach down to the jacks on the next shelf. Very few phono amps have their jacks in that location. The EAR 868, for instance, has it's on the far right of the rear panel, which is great if the amp is placed to the right of the table (looking at them from the front). All the ARC's I've seen have theirs exactly where I want them---on the far left of the panel (again, looking from the rear).
Hello BDP,

Another reason to look here :-)

Liberty B2B-1

And I do make them but you already know that

Good Listening

Peter
Yup, I noticed that Peter. Good thinkin'! Say, are you gonna have a room at the Newport Show later in the month?
Yes indeed, will be in three of them on the 14th floor. Our Own PBN Room will feature the complete InnerChoic line of speakers, Sammy, Hadley and Liberty. Powered by our Olympia line of Electronics, PXi Phono, DX DAC, LXi Preamp and a pair of EB-SA1 Amplifiers.

Next to this room Madisound will feature the ScanSpeak B741 and the XmaX speaker kits designed by me, they will be powered by a complete Liberty Audio Setup, B2B-1 Phono, B2B-2 Preamp DAC and B2B-100 Amplifiers.

Across the hall in the Quintessence Acoustics room they will debut their new Stealth VII Loudspeaker System (We build all their Speakers) they will be powered our Olympia Line of Amplifiers, Pi Phono, DX DAC, Li Preamp and a pair of EB-SA1 power amplifiers.

All rooms will feature one of our GrooveMaster Vintage Direct turntables.

Hope to see everyone there, It'll be a GREAT show !

Lots more information here

Good Listening

Peter