Top resistors

Some developments, now came the mundorf m-resist resitor as a temporary fix till my 1 pathaudio replacement. I dont know what happened to the my pathaudio resistor which value went from 6.8ohm to 47k. It did not break but value went up so high i thought the tweeter had problems.

The sound of the duelund cast were had very spotlight detailed, too much of a good thing, internet streaming showed certain tracks distortion very clearly.

I could only try the Mundorf available the nest day, now:

M-Resist, 1 went in the right speaker first, banished the duelunds with great relief! This was much more balanced with very good detail and has a tiny hint of sharpness as compared to the Pathaudio.

This may not be sharpness, but because the Path's are darker sounding (or more neutral), not as highlighted yet detailed. The Paths were more relaxed and smooth, allowing a higher listening volume without fatique. I believe that the slight hint of brightness associated with the steel legs on the mundorf's which i feel is the minus point in the design.

Overall, these mundorfs are the best balanced out of the 3 brands tested though i will revisit the Paths after the new replacement has been burnt in on my cooker.

"The sound of the duelund cast were had very spotlight detailed, too much of a good thing, internet streaming showed certain tracks distortion very clearly."

I haven't tried Mundorf or Path, but Duelund R took my Merlin VSM Esotar tweeter to a level of clarity and refinement that has ended the search for resistors for crossovers. Definitely not too much of a good thing. No interest here in obscuring detail from any source.

Dgarretson, yes the Duelund would likely be a very good match for the esotar.

With a metal dome it can be a little distracting, very defined detailed. The other resistors are very detailed and do not obscure detail, similar to when you use silver wiring (which the leads of the duelund are.

The Mundorfs surprisingly sound very close to the Duelunds and the Paths sounding a little more laidback and softer detais(you look into the details as opposed as the details coming at you which i do find it more more relaxed sounding..

I have tried many resistors in the preamp that I build. I do like the Vishay but also the Shinko. It also comes down to the placement in the signal path. I prefer the SHinko sound because it has what I would describe as a more real sound. The Vishay is close, it has a more open sound. To describe the difference, when I listen to female vocals and the person whispers, the air coming out of the lungs and out of the mouth sound very real with the Shinko and not the same with the Vishay. You won't know the difference unless you compare them. In my preamp I can dial in 6 different pairs of resistors on the fly so I can hear the differences immediately.

Bigkidz,
Thank you for the update on Shinko resistors. I see Shinkoh Tantalum Resistors offered at Hifi collective. Are they the same as your Shinko resistors -Regards Jet