I can't figure out how passive bi-amping (as pointed out in my Martin-Logan manual)in either vertical or horizontal modes offers more sonic benefits than using a higher-powered amp(usually better quality)in bi-wiring mode. Please enlighten.
I've done it with B&W 802 with tubes on top and solid state on the bottom,yes it can be done passively,and it eases the demands on the amps too.Make sure the preamp has 2 amp outputs.
If my poweramp has 4 channels and can be bridged to 2 channels, in general should I used 4 channel to passive biamp or bridge them to 2 channels. I'm asking in term of better sound quality only.
Supakit; biamping with a 4 channel amp is probably breaking new ground. I have read that "sometimes" bridging channels does not improve music quality/character. Good Luck. Craig
Supakit, try it both ways and tell us which way sounds better. I'm betting on the bi-amping. Let your ears decide, but get a quality y-connector and why not put it at the end of your present interconnect (female to two male with enough length to reach the two inputs)?
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.
