2. analog
  3. 1092104532

Is this why my analog rig isn't so hot?

Hi All,

My system is quite decent, but...

Could it be the voltage output of my Benz Glider is too high?

My photo stage - a 47 Lab PhonoCube - could handle low outputs down to 0.12 mV. Since my Glider has a medium output (0.83 mV) - is this why I'm not that happy with my system? I seem to want to hear more, specially the top.

If I got the same Glider but with a lower output, would it make a difference? Or should I get a better cartridge? And which one?

My system:

Basis 2000 table
RS-A1 Lab arm
Benz Glider (0.83 mV)
47 Lab PhonoCube phono stage
47 Lab Chooser passive preamp
47 Lab Gaincard amp
Konus Audio Essence speakers

Thanks!
George
ngeorge
rauliruegas
13,125 posts
 
Dear george: I don't want to miss the point: try to help you.
I think that you don't have to change your tonearm or electronics, the best you can do is to buy the Myabi cartridge that mates perfectly with what you have and is and exellent performer too.
In this way you will be near the top of analog music reproduction.
Regards and enjoy the music.
Raul.

Note: Sean I respect your point about the DL 103. Like many issues on music reproduction many things are a subjective ones ( like this ) and maybe your music standards are that of the DL 103 and the difference in our point of view is that my music standards are differents from yours.
dougdeacon
3,338 posts
 
Hi Raul,
Thanks for helping George with your experience. Good to know his Benz and RS-A1 are (or should be) capable performers.

I totally agree he should check/test all setup parameters (especially VTF and VTA) and certainly try higher loading before buying a new component.

I'm also not sure why you say tube electronics have a top end problem. Mine certainly don't. Obviously one needs to use the right tubes and load/match things properly. But judging by my system and others I've heard, tubes per se are unlikely to be the problem.
newbee
4,794 posts
 
Doug, thanks for reaffirming that tubes are OK - I was about to sell my SP10. :-) Strange stuff shows up here from time to time.
dougdeacon
3,338 posts
 
Newbee,
I was wrong, but it's your lucky day. I've got a Phase Linear 4000 in the basement. Wanna swap? ;-)
ngeorge OP
57 posts
 
You just don't know how much I appreciate the help you're all providing me. I'm truly humbled.

I used to think setting up was just screwing in the cartridge onto the arm, get a free-float, set the tracking force and I'm done. Little did I know I have to take the internal impedance into consideration (Gliders are more than 10 ohms), match gain against voltage output - Wow! I've learned quite a bit these past two days!

Raul, getting the Miyabi would certainly solve the problem, wouldn't it? Only thing is, the cost would amount to the price of my whole analog section! If only...

Regards to all!

George
More to discover