MIT Term 2 speaker cables...Am I nuts???

I had similar problems with T2 bi-wire cables. The mids and mid base were oddly recessed at a variety of frequencies, while the highs and deep bass were highly accentuated, making the system virtually unlistenable. I replaced these cables with simple 12 gauge speaker cable from Home Depot and everything cleaned up perfectly. I'm assuming that the problem was either bad internal assembly that caused it to provide a strange load to the amp, or simply poorly designed terminator boxes. Either way, I'm a bit gun shy about giving the T2's another try. If it provides any insights into the cable's behavior, I am using tube amps, although I did try it out with my old Adcom SS amp and found the same set of problems. Ken

I have these, and they sound warm with my Rogue 88, and even warmer (somehow) with my Krell KAV-250a (Made the Krell sound "closed in" by comparison, but there are other cable factors at play, also). I do notice that the treble and bass are softer, with less attack transient snap, and less detail at the extremes (especially when compared to Harmonic Technology Pro-9). I also notice that there is more dynamic weight to everything in between, which is a good thing. I also have Terminator 3 speaker cable (both 2 and 3 are full range, non-biwire), and have been using these in parallel (the T2 WITH the T3) with the Krell, to good effect. Any drawbacks in performance have been reduced by about 75%, and dynamics have increased. I should add that this is all with small 8 ohm monitor speakers, the Norwex Nisse B-2. I will try this with other speakers, as well, in a few days/weeks.

I guess I should add that I also have a pair of T2 BiWire. I was very pleased with what they did to the speakers I am using them on. However, I guess that were light in the bass before, so more bass was an improvement. The bass is NOT overly warm or bloated and I am using a CJ Amp which are definitely on the warm side. Have you played with speaker placement?? Maybe it is your room??

I believe that in certain systems, like everthing else, MIT cables are a good match. I was having trouble with my Thiel 2.3s, they sounded much too bright, and the instruments not at all natural. I am using a Krell amp that I only wanted to replace as a last resort. I worked with placement but it didn't help much. Then I went to a VTL 2.5 tube preamp which was a major improvement but still not quite right. Then I replaced my Kimber 8TC cable with MIT 750s, I burned them in for 3 days on another system. When I hooked them up the results were great, the highs were detailed but not harsh and the bottom end was as good or better than before. Now the system sounds very natural, the MITs worked extremely on my system which was very bright to begin with. In this case it was the right match.

I'm using MIT T2s biwire with PSB Stratus Goldi, B&K AV-5000II. Performance all across the board has provided a dificult to beat cost performance act.