Abe, I really do agree with you 100%. It does seem silly to spend dollars a foot on power cables when the Romex is roughly 10 cents a foot. I do not plan on spending my stereo allocation for the next six months on a power cable. Because of my electronics and electrical background, I will make my own. I started out by putting a heavier gage cord on my power amp. It helped, but I did not go farther with power cords because, like you, I felt that size was the issue.
I then got introduced to this and other forums, and all the talk about hospital grade outlets. I had a friend tell me about a hospital grade power cord. He sent me one and I compared it to a shielded IEC cord I had found. Both cords were a lot better than a standard computer cord. They both were even better than the heavy gage cord. The shielded cord had a ferrite 'bead' and may have been responsible for the lower noise floor and better focus of the images. I do not have the answers. I wish I knew what it is that makes a power cord change the sound.
I think we all can agree that a filter of any sort on the power line can have a positive effect on removing high frequency transients from the AC power. I have three filters in series on my power amp! I feel that it is possible that some of the high end cords might, because of their geometry, have special filtering capability. This could be at ultra high frequencies where the mutual capacitance of a big heavy inductor in an after market noise filter just passes it through, but the cord stops it.
My experience in industrial electronics has educated me to the hazards of a poor electrical connection. I have seen the results of a loose connection on a motor. The motor overheated from the reduced voltage and melted the insulation on the windings. Every connection in our systems can be a source for problems. Heavy current flow into the power amp could easily be restricted by a less than perfect connection on an outlet or cord. I had to put a slow turn on circuit in my amp to prevent blowing the 20 amp breaker in the distribution panel! I know that a magnetic circuit breaker can pass many times its rated current for a short transient before it will trip. My amp was likely trying to draw over 60 amps at powerup. Some will not believe that 12 gage wire can supply that much transient current. I know it to be true! I wired a 12 gage 100+ foot circuit going to a pump wrong and when I applied power to the pump it popped a 100 amp fuse instantly. Those little 12 gage wires handled in excess of 100 amps and did not melt or even burn the insulation.
The point that I am trying to make is that I feel we do not understand all the interactions that affect the sound of a system. My ranting(s) are for the purpose of shedding a little light on areas that may affect what we hear. I am sure that many 'discoveries' are waiting to be exposed. I know that discussions like this stimulates me to look deeper for a possible answer. I look forward to more discussion on this topic. Ideas or questions placed on this forum can be the spark that sheds light on a new understanding. I am certainly ready to uncover some of the *snake oil* in the high priced cables so that the less finically fortunate can afford good sounding cables.
Chris
