Biwiring

This could be a difficult question to answer unless one has no faith in bi-wiring capabilities. While I am a believer in the benefits of bi-wiring I am a strong supporter of using the best cable one can afford. Its my opinion that a much better standard cable (with good jumpers) will afford you better results than using the same value (you insert the dollar amount here) than bi-wires. I would say set your budget amount and audition comparably priced cables - 1 set of "regular" and one set of bi-wires - only your ears will count and of course its your wallet that will dictate just how deep you want to wade in... Audioadvisor offers 30 day returns and the Cable Co. does loan out cables (and is reported to be quite knowledgeable) for a small cost that I do believe can be applied to the purchase.

There are lots of posts on this topic, and from what I gather most folks believe that biwiring provides some benefit over a single wire. However, in my limited experience with bi-wiring a pair of ProAc's using MIT T-2 cable, I was rather unhappy with the results when compared to single wire. It may have been my particular installation, which at the time still needed to find the right balance of interconnects, or may be just a problem pair of cables, but the results I experienced were definitely better with the single wire cables. I found that the biwire cable presented a very unbalanced sound (overly accentuated lows, recessed mids and mid bass, and peaky highs with roll off at the extreme top end), which I didn't experience with any of the single wire cables I tried.

Anyway, as I said, lots of people seem to have had good luck biwiring, so it may be worth a try. I have been planning for a while to give biwire cables another run now that the rest of the system is properly wired, but summer seems to have increased my weekend laziness a bit ;-). Soon though...

Cheers,
Ken

Adding jumpers at the speaker posts only moves the signal separation point from inside the speaker to just outside the speaker. In a a true biwire setup, the separation is at the binding posts of the amplifier. I have rewired my Maggies so that the bass cable only 'sees' the bass network and the mid/hi cable only 'sees' the mid/hi portion. This is the real benefit of biwiring... the speaker crossover begins at the amplifier. The results can be debated, but I noticed a more seamless and open sound. The soundstage also had a deeper presentation. I am sure there are fellow B&W types who can recommend speaker cables. I would also like to hear their opinion on biwiring.

...Since biwiring does a speaker crossover at the amplifier level, the crossover point may slightly change up or down depending on amplifier. You will feel biger difference in biwired setup when you turn on and listen to unwormed amplifier ( especially tube ). You will feel bigger differences in sound when the amp has unstable gain (on very low volume or very high volume operations ). The volume control possibilities of the biwired setup is more narrow: the sound may become harsh on very low or very high volume of the amplifier unlike with single wired setup.

All of that because the crossover point cannot be stable in biwired setup. Yes it will improve the sound if the amp is in stable gain operation...

I don't understand how there can be a crossover effect at the amp binding posts. Can someone please explain?