Line conditioner for turntable,

I believe that both Walker and VPI make them available. Also, Origin Live has a DC motor kit that can be used in many different turntables. My TT is battery powered with a DC motor, and I found it gives a very good sound.

If you have an AC synchronous motor driving your table, I highly recommend the VPI SDS (Synchronous Drive System). Go on VPI's website for a detailed description of what this unit does (it does more than just condition your power). I have one and am keeping it around until something better comes around. VPI also has a PLC conditioner - less costly - for turntables (again, I believe only for AC synchronous motors).

Good luck

PS Audio power plants are, at least at face value, capable of speed control.

Ohala is correct in that the PS Audios can be used to provide 33 (60Hz) and 45 rpm (81 Hz, available with the upgraded power plants), but will not provide "speed control" in the sense of fine-tuning the speeds. The PS Audio sounded better than the original VPI PLC in my system, but the SDS sounds better yet.

If your TT uses AC motor I would go for a VPI SDS. The SDS does more than just condition power, it also allows very fine adjustment of motor speed and automatically lowers voltage after start up to reduce motor vibration. The PS Audio power plants can only change output frequency in steps of 5 Hz which is too coarse for speed adjustment.

If you use DC motor than I would choose a PS Audio power plant. A CD motor must be feed by a power supply. You won’t be able to adjust its speed by changing AC frequency and you cannot run its power supply at reduced voltage. So the two most important features of the SDS is unless in this case. A PS Audio power plant will give you the same voltage regulation as a SDS except it is more powerful. You can plug other equipment to a power plant in addition to your TT.