Plato, I am using a Rega P3 with its factory RB300 arm. Cartridge seems square with the headshell too, just the screws are off (there not side by side on the headshell).
Also another thing(for anybody to answer), on the Rega alignment tool I added lines horizantally in front of the cross. I then lined up the front wall of the cartridge to the drawn lines to check if they are parallel to eachother. Is this an effective way to check if the cartridge is aligned properly in addition to the printed lines on the sides of the cartridge?
Marcus
Also another thing(for anybody to answer), on the Rega alignment tool I added lines horizantally in front of the cross. I then lined up the front wall of the cartridge to the drawn lines to check if they are parallel to eachother. Is this an effective way to check if the cartridge is aligned properly in addition to the printed lines on the sides of the cartridge?
Marcus