2. cables
  3. 1010173661

Question about break-in method for interconnects

A dealer told me that an interconnect being broken in between a preamp and amp will only carry signal between the pre-amp and amp, and cycle the signal, if the amp is powered up and connected to speakers.

Others have told me that merely having the amp powered up is sufficient to have the signal cycle.

Still others have said that having the IC carrying signal to a turned-off amp is enough.

Perhaps it is component-dependent, but I would think that an interconnect running between a powered-up preamp and powered-up amp, whether the amp is connected to and driving speakers or not, is carrying signal and thus breaking in.

Which preamp / amp method described above works?

Thanks.
dearing
dearing OP
48 posts
 
Thanks to all of you for your insight.
Ag insider logo xs@2x
drubin
3,274 posts
 
The literature with my Marigo digital cable says that all you need for burning in digital interconnect is a signal lock between transport and DAC, so the transport does not need to be actually running..
brianmgrarcom
1,317 posts
 
I will echo the above, I was told by Lou at LAT International that the source only needs be on, (ie. Tuner, CD player, etc.), the preamp does not.

Your example was for between an amp and pre, if possible, I would hook the cable between a source and your preamp for breakin.

Lou further told me that speaker cables need to be broke in at volume.
bob_bundus
1,834 posts
 
In Brian's above example, interconnects again will only pass signal current if a load termination is present at the end of that cable. If you are connected from an operating tuner to preamp, then the interconnect only has a termination if the preamp's 'tuner' input is selected. If any other source is selected then the cable has no termination, no signal current flows, no breakin is occuring.
More to discover