What happened?

Hmmmm, "stupid enough"? Isn't that a bit harsh? It looks like Romy did not read the posting very well here. Since the LP sound changed for the worse even though the CD sound was unchanged, the focus should be of course on the TT/Arm/Cartridge/PhonoStage in the Hovland. Since the MM input is being used, I highly doubt this is susceptible to major changes in power vs the CD sounding as good as before. Is the Hovland MM stage that poorly designed? I doubt it. Perhaps a super low output cartridge might be more vulnerable to this.

It's not easy to analyze the change to thin and bright however. Generally when something goes astray in my system, the sound is more 2-dimensional as in a loss of harmonic richness. I swap tubes between channels and with spares to try and remedy this. Or the issue is an increase in background noise. This once was due to the shield on the phono connector not being tight. A quick crimping and re-solder and all was back to normal.

With a Koetsu cartridge, I could hear the slow degradation of the sound as it reached its end of life. One night the sound was suddenly greatly reduced. But again, it was not bright but rather the opposite. All the magic of the system had collapsed like the sound of the first generation of CD players.

You do not mention if the problem is one channel or if equally poor in both. Try disconnecting and reseating the phono cable. Also a quick visual inspection of the stylus and cantilevel is in order.

A visit to your local audio shop with your TT would save a lot of guess work on where to focus your attention with this problem. It could very well be the cartridge was faulty. And why not have the dealer assess this for you?

Hope this gives you some ideas.

John

It's also possible that your speakers are still breaking in, and will likely even out in the near future.

jd

A lot of good points brought up for you Carl. How many hours are on the speakers? Break in is a roller coaster ride for the first 400+ hours. The "dirty" power could effect your phone stage more so then any other component- its certainly possible(and Carl is in Boston, or at least I believe he is). Another potential problem could be with one of your ceramic midrange drivers, on my friends midi grand's he had crack's in one of his drivers which caused the system to sound VERY inconsitent and it was more noticeable with vinyl then digital. The cracks would be VERY tiny and hard to see, look through the grill with a flash light around the edges and see if there are any hair line cracks. I am by no means a vinyl guru so I will leave that up to the others! :)

Congratulations on the new speakers!

Jafox,

I do not think so. The recent degradation of sound due to quality of electricity is more observable on the better systems then on the dull. The fact that his CD still sounds “OK” says only about an unfortunate quality of that Accuphase player” it even with the good power lines sounds not particularly interesting.

BTW, to your information only during the last week I intentionally auditioned 12 totally deferent systems the sound of which I know very well and ALL of them demonstrated the VERY SAME sonic signature that never was there before. (Also I have a conformations from MANY other listeners). Besides… the problem might and has already been corrected by using the clean power lines… So, I might propose that my diagnoses was correct, or at least VERY plausible.

John, I understand that you have fan to BS about the application of the habitual “audiophileic wisdom” but unfortunately to sing the songs about the changes of the tubes, apply shielding and end of the life of your funny Koetsu will not work in this case. Fortunately for you, kids, there was an idiot who already went over all imaginary troubles after the sound suddenly died two weeks ago. The idiot knew what he was doing, and went through everything lately (!) event totally rebuilt his phonostage! This idiot was “Romy the Cat” and he shares it with your guy just in order you do not panic and do not rapid my stupid actions.

I have a number of VERY serious and very credible people who experienced the VERY same result at the SAME TIME in their context of serious and very capable installations. So, I am not kidding, and sincerely proposed that in Carl’s case it was the electricity. Besides it is very simple to verify. Are any bids accepted?

Good luck,
Romy the Cat
Sitting next to the dead system.

BTW:

The following email I have sent out least week:

“Guys,

I have a question to ask. I am experiencing very severe worsening of Sound sense the US” blackout started. The sound (both analog and digital) begins to sound like a chip digital from 70s : VERY harsh upper MF/HF along with a total luck of dynamics. Frankly speaking I spent a LOT of efforts to change tube and do the use audio BS but nothing helped. I assume that the problem somehow connected with the current state of electricity. Perhaps they use some type of auxiliary powers souses the screw everything up. Some of my friends in New England are experiencing the similar results.

I BCCed this email to the people from the different locations within US and Canada and would like you to reply if you find that you experienced the same problem during the last 10 days.

I appreciate your replies.

Rgs,
Romy the Cat"