"Floating ground" and Electraglide Fat Man p. c.?

Dear Mshan, use a multimeter and check the impedance between the (2)grounds. (1) on the plug and (1)on the IEC (middle contact on both). Switch the multimeter to the Omega. If it is zero or close to it, you are grounded, if it reads infinite, you're floating. Hope this helps!
Dan
dedicated audio™

Just received 2 Fat Man Ks from a dealer on Audiogon.
Both have faulty or non-existent ground/earth terminals.
Needless to say this is potentially dangerous, and could also degrade sound quality.

A fairly knowledgeable poster at audioasylum responded recently there to this same thread over there that this cord comes standard with no ground and that grounded cords are made only on request. FWIW, many of the cords that I've used have sounded much better with floating grounds. Safety, I guess is another issue.

Yes,
I have just queried the two dealers for Electraglide here at Audiogon:
Standard reply is that the floating ground is usual for all Electraglide cables
You have to opt for the ground, and the floating ground cable is better sounding (according to the dealers).
I would have liked to have known about this before ordering the cables. In fact I had pointedly asked one of the dealers about the floating ground and he did not seem to know about it until he asked Scott Hall at Electraglide.
This was after I had made my purchase and received my cables: Fat Man Ks.
With a high current amp and no ground, there is a safety issue, like it or not, particularly at 110 V.
The sound quality issue I honestly do not know. I am unable to make an A/B comparison as all I have are floating ground Electraglides! Theoretically removing the ground can eliminate ground loop problems if you have them. However according to Russ Andrews (one of the original gurus of power cables) this is not an ideal solution. It is better to have a chassis ground and solve the groud loop problem: please look up his free downloadable booklet on power supplies/mains etc at www.russandrews.com