loading impedance

You have to take into account the electrical characteristics of the tonearm cable and interconnects used when setting the loading characteristics inside the phono stage. As Vvrinc stated, this may take some trial and error testing to see what works best in your system. Sean
>

I can test the phono section for different impedance but with some difficulty. I have to purchase resistors and unscrew two screws in the back and put new ones in, unfortunately there is no easy dial like some phono sections. will the trial and error be totally the sonics of normal album play? Having not done this yet what can I expect from different resisters? The preamp/phono section is a atmasphere mp1 and the turntable is a walker, possibly the brands names can lend more information. thanks for taking the time to help out.

I own that Cartridge too. I use it with 47kohms. I tried some other ( lower ) settings and it became dull and slow.
And I lost information then. But I can imagine, this can can vary from System to System.

Sean and Thomas,

Thanks for the tips. I did the impedance settings when my Z1000 was brand new. Out of laziness, I didn't fuss with the Ono's settings. For a couple of days now, I have tried 47kohms (a bit too bright in my system) and 1000ohms (seems so far to offer what Thomas had mentioend in his post without the brightness.)

Eralff, if your cartridge is a new one, waiting a bit for the final impedance decision may be necessary. Mine is about 100 hrs. old. In another 50-or-so hrs. I'll give 47k another go.

Best regards.

In general, As you increase the resistance of the resistor you will get stronger high frequencies. The secrect is finding the value between too dull and too bright.

Radio Shack sells (or at least used to) an assortment of 1/4 watt resistors that should give you all the values you need. Once you find the value you like you can replace them with audiophile resistors if you wish.