Can anybody define LOW OUTPUT...?

This actually has a very real application (believe it or not). I'm going to pack it in with my preamp phono stage if 0.1mV is FAR lower than something I end up buying. So - if the 'low end' - or, in other words, what most designers AIM for is above 0.25mV then I probably need to find my game somewhere else.

thanks for the input, though!
Jonathan

If that phono stage is really designed for the Linn Troika then it should be presenting a load of 560 Ohms and has maybe 70 dB of gain. You are right that this is more gain than many moving coils need, but it's hard to guess without knowing the component specifications a little better whether this will overload the complete chain (phono-line-amp-speakers-room) when driven by a cartridge with 5 times the output.

Even if not overloading the system, you may not be in a very sweet spot on the volume control - too much volume at very low settings.

There are a few moving coil cartridges that also have a very low output like the Troika, although I can't think of them off hand. What about a Troika?

Can you try the cartridge you are considering before you commit?

Regards,

Thank you very much for your considered response... I think this is getting me closer to deciding whether to commit to a troika or try something else and change my phono stage out for something else (luckily my preamp (naim) uses different interchangeable boards for the phono stage. I just wanted to know how much of a problem this might be. Another pickup I was considering was a vdH - at around 0.5-0.6mV.

What IS interesting is that I'd be willing to bet that using an overly sensitive phono stage would CONSIDERABLY change what I'll call the 'electrical profile' of the signal being sent to the power amp (impedance, etc...). I wonder how audible the difference would be.

Jonathan

using an overly sensitive phono stage would CONSIDERABLY change what I'll call the 'electrical profile' of the signal

Well, amplifying a very small signal is always prone to external attack (noise, etc). Also, in a smaller signal you're more dependant on the amplification & the wires, whereas in a higher signal you;re more dependant upon the quality of the coils...
Mr V den Hul once said that, ultimately, one might be better off with a higher level signal fm the cartridge and depend less on the phono. IME, differences were slight either way...

One thing that's palpable is: it's usually cheaper to get more output fm the cartridge than the extra 15db (10? whatever) amplification fm an outstanding phono. Cheers

CMK has it right: low output is around .25 or .3 MV, phono section gain needs to be 60db or so.
I've always thought the low outputs were better.