Trans Temp W, Magic Diamond cartridges - comments

It was a Benz Ruby 2. Keep in mind though that the Benz line has a rolled off top end.

Reb -- I could only find an internal impedance spec for the .3mV version of the Ruby 2. It is 45 ohms (the .34mV might be a little higher.) Its loading range is spec'd at >400 ohms, and our "formula" (25 x internal impedance) predicts an optimum load at 1125 ohms, with a high-optimum of 50% more, which would equal 1700 ohms.

So you can see that, unless you did an A-B and listened carefully, you might not hear that much difference between 1700 ohms and 22k ohms. But make no mistake, there is a difference! I'm not that familiar with Benz, but if they have a rolled-off high end like you say, running them into a higher load might compensate somewhat, but you'd also be "throwing away" some low end output. How much would depend on the cartridge/arm's low end response.

I've owned more expensive cartridges, have a couple of spare VdHuls on top of my refrigerator, but I really like my Transfig. Temper V (.38mv) Very neutral without being un-musical.

Before this thread dies off into the archives. I just wanted to say that I'm absolutely thrilled with the Temper V. If there is one thing I learned in high-end audio that can't be disbuted IMO. It's the fact that it all starts at the source. So, the source in vinyl replay is the cartridge. I find nothing...zero...nada...to criticize about the performance of the Temper V. The sound, true to the source as well. What do I mean by this?? Analog tape, the Temper V sounds like analog tape is playing in my room. What more could one ask for.

I wanted to mention something about the issue of MC cartridge output. Manufacturers use one of two different test records to measure cartridge output. The JVC (TRS-1007) at 3.54 cm/sec, and the CBS (STR-100) at 5 cm/sec.

Make sure, when you are assessing output figures, that you take the cm/sec figure into account.

For example, the Lyra Titan is rated at 0.5mV, and so is the Transfig W. But the Titan's output was measured using the CBS record (at 5 cm/sec) while the W's was measured using the JVC record (at 3.54 cm/sec). Had the Transfig W also been measured using the CBS record, its output would be well over 0.6mV