Red Rose R3s vs. Proac 1sc vs. Dynaudio 1.3SE

Gosh, with all these great testimonials for the Red Rose 3s I'm becoming very interested in them. I've been living very happily the last few months with my ProAcs, but you folks have got me thinking now.

Especially, when the Red Rose 3s are described as being lush and beautifully voiced. Any thoughts on how they might sound with Simaudio amplification? Are they better suited to tubes?

I thought the doctor cured my last case of upgrade-itis. Oh well.

funny the red rose r3 uses a transducer suspiciously like the raven r3.1

I have listened to the Red Rose R3's a number of times and I was not that thrilled the first time ( I was in the market for this kind of speaker. Yes I did buy one of the speakers in question ). The second time that I heard them there were connected to the Red Rose integrated amp and they sounded fabulous. So I thought that maybe that the setup was bad on the first trial. But I went to hear them again with Sim Audio hardware and they were strident and all shrill and the two drivers were not matching well at all. Now, maybe it is different strokes for different folks 'cause I am obviously in the minority here. Recently I found out that a local audio store is no longer carrying them due to the same type of reasons as I have heard. I purchased the Dynaudio 1.3 Se's and I feel like a most favored man because I have found a speaker that sounds completely right to me. Go figure why don't ya!

Try the PMC LB1s. I've heard all the speakers you have mentioned and they were the best by a wide margin. I heard the R3s at a show and they were played so softly it was not showing them off properly. Anyways, if it were my money i would not hesitate to go for the PMC LB1s. Look on bryston's website for more info. Thanks

Agree with you Mcne. I recently heard the Red Rose R3's and they were thin, shrill and obviously cut of several different cloths. Very un-impressive indeed. Could have been the set-up--but?
This probably tells you that a home audition is a must when buying a speaker. Sometimes a manufacturer gets it all wrong but can't go back to the drawing board because of cost. I wander if this is happening a lot in the high-end these days.