Stands for Soliloquy 5.0 Monitors

Play with the positioning. I had the 5.0's on their own stands with a Bryston integrated and it was a terrific combo -- no thin mids in three different rooms I used them in. Maybe you need to biwire or upgrade the speaker wires? Maybe pull them out a little from the wall? I'd think of some other solution than replacement of the stands, as those Soliloquy stands are pretty awesome -- better than a lot of other stuff costing more, and mated perfectly with the 5.0's.

Just my opinion. And FWIW, I can't imagine the problem is your amp. So I would try positioning, wire, and I guess third, source -- although you didn't mention what your source was, so for all I know it's a 50K Burmester combo.

Good luck,

Rich

The only thing that changed was the stands so that is where I'm focusing my attention. Did you fill your Soliloquy stands with sand? Completely full?

Chris

If repositioning the speakers does not work you could try decoupling the speakers from the stands by unbolting them and try using audiopoints (three per speaker, two in the front and one in the back) between the speaker and stand.
Regards,