2. speakers
  3. 1109022367

Installing Bucket Magnets


Hey folks, im getting ready to install some Bucking magnets in my JM Lab 707s and a pair of Velodyne Subwoofers in order to shield them for the TV.

Looks straight forward, epoxy the magnets to the rear of the drivers.

Has anyone done this before? Any complications you have come across that i should know? Any advise?

Thanks!
slappy
ghostrider45
449 posts
 
If this is one of the servo controlled subs, be careful. Changing the electrical parameters of the speaker may make the servo system unstable.
slappy OP
903 posts
 
Not a servo sub. DLS-4000, top of the line model of a mid level product line. LOL
theaudiotweak
2,806 posts
 
Every answer posted is the correct answer. I used in the past bucking magnets to make a shielded center speaker before ther was such a thing..We used silicon and wire ties to hold everything in place till all was cured. The sub may not be a factor...because of location and height relative to the crt's placement..Tom
slappy OP
903 posts
 
Thanks for all the feedback folks, i should have the magnets by this weekend and should have everything done by next week. Ill be sure to post my results. :)
eldartford
4,262 posts
 
Do the SW actually distort/discolor (discolour for sean) your picture? Why not just move them away a bit. SW are sort of free to roam around the room.
More to discover