Where do the tubes go?

I bought a new factory upgraded Jolida 502P for a little over a grand, it requires almost zero maintenance (you don't HAVE to tube roll, and the bias adjustment screws are easy to get to on the top of the amp), and sounds fabulous right out of the box. RCA and XLR ins, 4 and 8 ohm speaker outs...all user friendly. Don't be frightened...it's easy...come on in...

I believe the talk about tube amplifier maintenance is often over stated. They are actually quite simple to own based on my ownership of various models the past 20 years. My current 300b SET amp has been utterly a piece of cake to have and is fuss free. Auto bias and just three tubes per mono block. Jump in the water`s fine.

Charles, Your experience has been fine, but is by no means universal. A major hurdle, IMHO, is matching the tube amps output impedance (curve) with the speakers frequency response. Not a simple issue for most, but especially for a tyro who has no experience with the wide range of possibilities available to him and can easily chose an amp that will sound like crap just because it is a tonal or electrical mismatch. He will need guidance by some one familiar with his speakers, his environment, as well as what he expects tonally. Just determining the type of amp he will enjoy most is no small task. A 300b amp is just one of many possibilities which will work fine.

Maintenance wise, the only really major issue, apart from the quality of the units themselves and their ability to provide long service with out premature failures, is, if one is not a techie and has an amp which blows out a resistor when he has a power tube failure has to truck the amp off to a repair shop or mail it somewhere for repairs. Simple repairs, not too expensive, but many tube amps are very heavy and a PITA to haul about. Now if he were a techie he could simply replace the resister himself. No big deal.

I think telling someone to just 'jump in, the waters fine', should only be given to someone to who has learned about the water, i.e. its depth, temp, and any hidden currents, so they will not just find themselves over their head and freezing after they jump in. :-)

FWIW I have several high power tube amps which are or have been, ultimately, fine boat anchors. ARC, Sonic Frontiers, Mesa, Cayin, and some I've probably forgot.

Newbee,
We are all just sharing our individual experiences which surely will differ.
Amp- speaker match is of course a factor, but this applies to "all
amplifiers" not just tube models. Any solid state amp just can`t be
tossed into a system without some thought and consideration.Perhaps my
experience with tube amps were less problematic than yours or things
worked out differently for what ever the reason. I do agree that some
degree of research is necessary to get the right match. I however don`t
believe tube amps are some exotic beast that must be handled carfully
while SS amps have no concerns at all and just work with any speaker,
they don`t. Anyway we`re just two guys trying to be helpful with our
different perspectives, we both mean well. Sorry about your problem with
boat anchors-
high power tube amps, personally I much prefer the low and moderate
power tube amps with efficient easy to drive speakers.
Charles,

I would start with a tubed pre-amp or a self-biasing integrated amp. You will be able to roll tubes to experiment with little technical skill. Also Wolf Garcia's suggestion of Jolida which is easy to bias.