Need a warm amp for bright speakers


So when I bought my system some time ago I made some mistakes being this the first time I ever ventured out doing this. I bought Paradigm Monitor 9 v5 and a Pioneer VSX21TXH. Surrounding speakers aer all Monitors backs are Titan v5 and center is a 290 I believe v6. The SVS kills though. The fronts do get very bright when pushed especially with metal that I listen to and it is VERY BRIGHT. Without redoing my whole system is there a way I can tame this problem? Use my Pioneer for maybe center and rears and processing and a dedicated amp for the fornts? If so what should I shoot for? I hear NAD is a good warm amp. I don't want to sell or get rid of the Paradigms because getting all new speakers would be far costlier than a dedicated amp. However I am a little skeptical that I can solve this with just and amp. All ears open for a relative newbie.
mmartin0617
Well if the OP wants to try and tune in his current speakers he should use Cardas Copper cables (the best he can afford) and use a Tube Integrated or power amp. Once he has the amp he can roll tubes to achieve an even warmer sound than the stock amp usually has.
There are some warmer, softer edged SS amps, Cambridge and Creek come to mind but there are others of course.
I do think a tube amp might be smart...

My question is, is it a bad idea for the OP to tone down his rig in order to make a bright speaker sound neutral? What happens if he goes with a more neutral speaker later, and now his other components make a neutral sounding speaker and make it sound super laid back? Honest question in which I don't know the answer, just something I was thinking about in order to helpthe OP...
NAD will do the trick and should not cost a lot to try especially if you go used/vintage.
Personally, I would buy the best amp I can to match your speakers and use tubes up front in the pre-amp and/or source to get the tonality desired, warm or otherwise. NAD power amps would be a sound choice but many others as well under this model.
The one suggestion I would make that hasn't already been said is that before replacing anything you try changing the receiver's speaker impedance setting from 8 ohms to 6 ohms, if you already haven't. See page 40 of the manual.

Although the impedance of your speakers is specified as "compatible with 8 ohms," whatever that may mean, it most likely drops down to significantly lower values at some frequencies. Therefore using the receiver's 6 ohm setting might result in an improvement in its distortion characteristics, and therefore perhaps a reduction in perceived brightness.

Regards,
-- Al