DIY AC cable...which bulk cable?

I recently bought an Acrolink 7N with the Oyaide P-/C-004 connectors and find them to be quite neutral. With the Acrolink 7N what you're basically "hearing" is the connectors much more so than the power cable itself. I have the same P-/C-004 connectors on the Acrolink 6N cable and find it a little warmer sounding and not quite as good at disappearing.

One point to keep in mind regarding my comments, I'm using Oyaide's R-1 outlets so there may be some synergy going on with the connectors since they follow the same plating structure of palladium over platinum over beryllium copper.

Neotech and Furutech both make a number of bulk power cables so gets complicated as some are shielded, some are not. Also different purity of copper and size of conductors, etc, etc.
I've found that the larger the conductors the more difficult to build the cable so go only as large as you need. Maybe shielded for source components and larger, unshielded for amps.
I like the Neotech cables because they come wrapped in Techflex which is another cost with other brands mentioned.
I've built 2 Neotech NEP-3001 and 2 NEP-3002 (all shielded).
Thinking about building a Furutech FP-Alpha 3 (unshielded) for my amp soon.

Joe, I also have the R1 outlet though in my case I wil be plugging this cord into my PS Audio P3 ac regenerator.

Rja, would you suggest going the unshielded route for my linear power supply? I have heard that amps need unshielded power cords though I have no idea why.

I have 2 R1s in my power supply but just my digital source components are plugged into it. My power supply has shielded NEP-3001 going into it.

As far as shielded/unshielded depends on your environment and what you're plugging into the power supply. Possible it may not matter.

Also, shield on shielded power cables has to connect to one of the connectors so you will have to unbraid it and twist into a wire to connect to ground (if I remember correctly the male connector, floating on female end). Some cables have a shield drain wire which makes it easier but should not be connected at both ends.

Caveat: Hope this helps BUT I am no expert, please consult other sources before building your PC.

Tboooe - I think you misunderstood - I found the home depot cable to be as effective as the furutech cable, but only in this instance

So, for computer power cables I think you can used a much cheaper cable.

My findings for all my other hi-fi components was exactly the opposite - quality power cords are essential as you well know

Regards