UPgradeing dedicated line components


Six months ago I installed 3 dedicated lines for audio. One to amp, one to preamp, and one to digital. I used standard solid core 10ga romex for amp and 12 ga otherwise. I have a Square D box with distance to outlets not more than 20'. Used hospital grade outlets, however inexpensive ones.

I seek input on value of:
1) Upgrading the breakers in the square D box.
2) Replacing the romex for 10ga stranded cable for all lines.
3) Upgrading the outlets to PS audio or something of ~equal value.

Thanks in advance for any thoughts. Mike
mesch
I understand my set up is not in compliance,but it works for me.
The wires are not in contact with any carpets or surfaces that could become flammable.

I think I have read about fires starting with electric wiring buried behind dry wall and wood framing, so perhaps the code has it's flaws.

In reality, what I am doing is no different than someone using extension cords.

I can break the signal at the amp, it's not hardwired, which I believe is a valid code violation.

So, are the folks who run extension cords to their amps from a wall socket also violating the electrical code?

How about the fellow with a current hungry amp using sub standard 18 guage extension cord?
I could see that wire overheating in this case.

10 guage romex, not so much.
If it's going to overheat and cause a fire, then there's more chance of that when it's buried behind insulation in a wall.

I am not stating that what I do should be done by anyonelse.

Your options will provide inconsequential improvements.
Consider isolation for your preamp and then digital and then amp. Digital hash plays havoc with sensitive amplification. Even fairly modest older MIT Z Stabilizer 2 (plugged in parallel) will likely improve your sound quite dramatically.
Very much appreciate the exchange between Lacee and Zephyr. I now have a focus on room 'tuning' .

Ptss, I have considered power conditioning for pre and digital. Currently using a Monster cable conditioner for digital. (DAC and DVP) Keeping digital isolated.
Why not install a small reactor in the basement and eliminate the 6 million feet of feed line, bad connection , inline service fuses , noisy transformers and years of oxidation. Ground it properly and use quality outlets that have a firm grip on your outlet and treat the room and spend the hundreds you save on music......
If such a reactor based system made the music sound better then I'm in favour of it.
It's all about the music afterall.

Just respect the music by doing all you can to reproduce as much of it as is possible.

What good is ten thousand lps' when all you can hear is 10% of the music that's in them?

That's just as absurd in my book.