2. amps-preamps
  3. 1127956347

Calling all MC275 MK IV owners..............

I just set up my new MC275 and although the tubes have about 90 minutes on them, I'm blown away by the sound - I wish I discovered tubes 10 years ago.

Anyway, a few questions:

1. What gain level do I set the amp to. I cranked it all the way up but is there an "optimum setting?" I'm running these in stereo mode with unbalanced connections.

2. In a couple of days another MC275 gets delivered and I plan to run them in mono mode also using unbalanced connections. What gain setting is optimal for that configuration?

3. I have the amps on a trigger switch and noticed that on power up the tubes sort of glows a bit brighter for a second then settles back into the normal orange filament glow. is this normal?

4. What is tube rolling?

Thanks for all your help. I really appreciate it. Sorry if these questions are a bit stupid.
128x128pookie10
tomryan
796 posts
 
Don't worry about tube on tube getting fuzzy or hazy. I've been running like that for years and years and with the right equipment, get magnificent music making. Just last night I was listening to a Gene Ammons CD which sounded open, clear, and as if the band was right in the room. And this with a tube pre-amp, SET tube amp, and I am sure the original recording was done with all tube studio equipment.

Both tube and SS stuff nowadays (and going back a few years) can make beautiful music. There are tube designs which can sound a but fuzzy and hazy (older C-J stuff) and designs that can sound crystal clear and almost over-lit (Some OTLs). You have to check out each piece on its own merit.
bigjoe's avatar
bigjoe
693 posts
 
i own the c2200 preamp & i love it,i ran a mc2102 on the c2200 & the 2 tube units paired up nicely,you shouldnt have a mismatch with the c2200 mc275 combo.

mike.
Ag insider logo xs@2x
superhonestben
199 posts
 
I use a C2200 into the MC275 1V and it is a killer, another way you may want to try is getting a VTL 2.5 tube preamp, if you don't need phono they are pretty inexpensive new and less here on the Gon. the 2.5 into the Mac is also a great combo.
vincentkkho
53 posts
 
I don't think there is any optimum setting for the gain. It all depends on your speakers placement and the preamp that is coupled with it. The other factor to consider is the size of your room and the distance between the speaker and your listening position. Once all these are set, I would advise you to firstly set the volume control knob on your preamp to a predetermined setting. You will than go on to fine tune the gain setting in both MC-275. Try to play with the gain till you get the best result ( of course all depends on your ears). That is fun!
I would advise 12AX7 and 12AT7 to be used for all the small tubes. I did not have good result for 12AZ7, which was recommended by McIntosh before.
Hope it will help. Happy listening!
pookie10's avatar
pookie10 OP
41 posts
 
More tube questions............just received my "back up" set of output tubes. 8 Winged C KT88 tubes. 6 of them have a bias of 45 and 2 have a bias of 44. According to the McIntosh literature, the MC275 is self-biasing. Since I have NO IDEA what ANY of this means, is it a problem that 2 of the tubes are "off" by one unit?

Also, the small output tubes say 12AX7A but all I could find are 12AX7 (no A). What is the difference?

I'm also looking for input tube recommendations. I'm running both in mono using the RCA inputs.

Thank you again for your help.
More to discover